User Manual

page 20
... print your plane | www.3DLabPrint.com
10. Pilots Please Attention!
For the first flights we recommend to set the center of gravity of the airplane by about 5 mm
forward of the CG tag - nose heavy, this increases the stability (you can use heavier battery).
Also is good to increase expo settings on your transmitter for elevator and aileron to 60 %
(this calms response from your stick inputs). Also you can decrease elevator and ailerons
deflection.
Make sure the battery is well fixed in proper position. If it moves during flight it will cause the
CoG move aft and can lead to uncontrollable flight behavior.
You can then return to the proper center of gravity (balance aircraft). Set expo to
30-50 % ... this will gain back extra maneuverability when you are confident with flying your
airplane.
Spent at leats 10 hours with RC flight simulator before you go out for the first time.
Flite test: RC Planes for beginners (but note: we use primary ailerons for turn, not only rudder)
Never fly aft positioned Center of gravity.
Please, use these files only for your own purpose, do not
send it further. Thank you very much. Enjoy your flight.