User Manual

page 19
... print your plane | www.3DLabPrint.com
8.1 Decals
Cut decals from thin advertisement foil or use any advertisement company around you for
make it. Glue it at your model by your choice.
See video guide #9
You will need: Decals from advertisement foil.
9.1 Motor, battery, RC equipment and final assembly
Glue battery holder to fuselage. Mount motor by 4x M3 screws (move shaft to front). Push
controller at bottom of battery holder. Install your receiver, connect battery, setup servos and
etc. with your trasmitter, check servo position. Set recommended deflection from videoguide.
Check CoG point (see CG- marks on wings). As the last step mount propeller at motor shaft.
Note: maybe you will need solder 3.5mm conectors for your motor and ESC setup...
Make sure that the battery is placed properly and secured. If battery moves during flight it can
shift the center of gravity backwards and aircraft will be uncontrollable!
See video guide #10
You will need: Your own Rx/Tx system
Turnigy 3542/5 1250KV or similar
3S Li-Pol 2700-3300mAh
40A Electronic Speed Controller
9x6 propeller
Adhesive velcro strip for Li-Pol battery and ESC