User Manual

page 17
... print your plane | www.3DLabPrint.com
6.1 Servo installation
Our Qtrainer was designed for 4pcs of standard mini servos 30x30x12mm. We tested it with
Hitec HS-82 and Corona CS238MG. Mount two servos to fuselage. Make Z bend at correct
legth of pushrods. For wings use servos with extension cables and glue it to servo bays. You
can cover holes by printed servo covers.
See video guide #7
You will need: 4x Hitec HS-82 or similar, size: 30 x 30 x 12mm servos
2x servo extension cables 300mm / 12 inch
1 mm /14AWG pushrod wires
Wire cutter, Z bend pliers or pliers.