User Manual

page 16
... print your plane | www.3DLabPrint.com
5.3. Fuselage tail - rudder, elevator pushrods and servos
Now is good time for install tail stabilizers, elevator, rudder and pushrods. You can use snap
knife to clearing shape of printed parts. Glue rudder parts, horizontal stabiliser and elevator.
Insert complete horisontal stabilizer to fuselage a lock it by two small screws. Use 1 mm
/ 14AWG pushrod wire for elevator pushrod. Make Z bend or use your liked pushrods
attachment. We like this Pushrod Keepers. Thread pushrods and glue the elevator and rudder
in correct position with CAglue and hinges.
NOTE: Complete horizontal stabiliser without elevator on the desk. Elevator install separately
as last step to tail for easy pushrod mounting.
See video guide #6
You will need: CA Glue - medium viscosity CA glue
Activator for CA Glue or similar, but gas presurized aerosol is better
1 mm /14AWG pushrod wires
Wire cutter, Z bend pliers or pliers.
Snap knife
2x small screws
rudder 1
3g/0.10oz
rudder 2
7g/0.24oz
rudder 3
6g/0.21oz
elevator R 2
12g/0.42oz
elevator R 1
14g/0.49oz
elevator L 1
14g/0.49oz
elevator L 1
12g/0.42oz
elevator R 4
9g/0.31oz
elevator R 3
12g/0.42oz
elevator L 4
12g/0.42oz
elevator L 4
9g/0.31oz