User Manual
page 15
... print your plane | www.3DLabPrint.com
5.2 Fuselage assembly
Glue fuselage parts F1-F9 with CA glue together (position locks will help you) use activator.
You can use snap knife to clearing shape of printed parts, but mostly it is not necessary.
Cut and remove plastic from upper side of fuselage. Glue 4x strong PIN for wing rubbers.
Insert pen spring to canopy part, insert canopy lock, glue both canopy parts together and test
a canopy lock functionality. Test perfect fit canopy with fuselage and canopy lock functionality.
NOTE: Don‘t glue the tailparts yet !!! (for rudder, elevator and horizontal stabilizer proceed
to next step)
See video guide #5
You will need: CA Glue - medium or similar medium viscosity CA glue
Activator for CA Glue or similar, but gas presurized aerosol is better
1x ballpoint pen spring (a spring from old ballpoint pen will work fine)
Snap knife
optional: Soldering Iron or any hot tool
F8
36g/1.26oz
F7
54g/1.90oz
F6
48g/1.69oz
F5
44g/1.55oz
F4
41g/1.44oz
F3
32g/1.12oz
F2
22g/0.77oz
canopy lock
2g/0.07oz
canopy
2x 9g/ 2x 0.31oz
F9
44g/1.55oz
4x pin
6g/0.21oz
battery holder
9g/0.31oz
F1
35g/1.23oz