User Manual
page 13
... print your plane | www.3DLabPrint.com
Basic Tips and Advice
Please experiment with your extrusion multiplier.
Also HotEnd temperature is very important for a strong result. Please try increasing the
temperature to find the best value (215° up to 260° Celsius).
Turn OFF cooling fan for better layer adhesion (HE fan of course ON). We don‘t need it for our
thin wall printing. You can use cooling fan for thick parts...
We try lot of filaments and so far PLA is still the best for our models (2017).
Heated bed is very recommended, 50-60° Celsius (print without warping ends).
Looks like any standard quality PLA is perfect for our planes, but it always depends on
combination PLA vs. Extruder vs. HotEnd.
We find that some color of filament has lower layer adhesion also.
Nowadays there are a lot of 3dprinters on the market, most of them are OK for printing our
aircraft (specific thin wall printing...) sucient volume, heated bed, 0.4 mm nozzle.
Please look at FAQ and our Forum for next information:
Need a help? our Forum is the best place... where we can help you