User Manual

page 11
... print your plane | www.3DLabPrint.com
option D CURA or MatterControl (but note: we recommend Simplify3D)
MatterControl and CURA are free :-) and also give very good results and the airframe is still
strong enough. The slicer setting is very easy.
Please try to find the right extrusion multiplier and temperature for good weight and best
layer bonding. Look at parts weight list for proper multiplier settings.
You can also use our predefined CURA or MC slicer setting file included in the package (always
adapt it for your printer, change build volume, filament diameter and so on... depends on
your printer!!!):
CURA_wing_fuse.ini (wing and fuselage parts) for part9 add botom and top + infil
CURA_ailer_elev.ini (only ailerons, elevator and rudder parts)
CURA_thick.ini (cannopy lock, landing gear... )
OR
MC_wing_fuse.slice (wing and fuselage parts) for part9 add botom and top + infil
MC_ailer_elev.slice (only ailerons, elevator and rudder parts)
MC_thick.slice (cannopy lock, landing gear... )
AND... please look at VideoGuides:
video CURA slicer setting CURA 2.3.1 import setting
video CMatterControl slicer setting