User Manual

the world‘s best designers united
3DLabGANG project by Michael Hammer
Fuselage_04 and 03 are the most difficult parts to assemble because of the bifurcated EDF
ducts. Make sure to bevel the outside edges of the ducts with sandpaper and the inside
edges of the receiving opening. Take your time and repeat the sanding until both parts slip
together nicely. If you don´t succeed at first then put it aside for a while and jump ahead and
assemble the elevons or the vertical stabilizer. Then come back and try again.
After the hopefully successful assembly of Fuselage_03 and 04 the two remaining forward
fuselage parts Fuselage_01 and 02 are very easy to assemble. Be aware that Fuselage_01 has
a small mark on the inside flange that indicate the top of the part. You can also look at the
location of the stringers which should all line up with the stringers of Fuselage_02.
Now it is time to finish the fuselage by adding the final two fuselage parts, Fuselage_10 and
11. Both parts are printed in the opposite direction of the other 9 fuselage parts. So make
sure all edges are nice and clean both on the in- and outside of the parts. Assemble the parts
using the same procedure as the previous parts.