User Manual

the world‘s best designers united
3DLabGANG project by Michael Hammer
Continue with fuselage_07. Route the servo extension wires through Fuselage_07 and fit in
together with Fuselage_09 and 08. Take your time getting the parts lined up perfectly
before adding any glue.
It is now time to add the EDF thrust tube. Cut a hole in the tube with a soldering iron, hot
knife or Dremel at the marked location for the EDF motor wires. Test that the EDF tube will
easily slide onto the FMS 50mm EDF unit and the motor wires can exit through the hole you
just cut. Remove the FMS 50mm EDf from the EDF Tube. Insert the EDF Tube into the EDF
Duct of Fuselage_06 and slide it all the way in. It should slide in and out with just a bit of
resistance. If the fit is too tight, remove the EDF tube and sand the outside until the EDF tube
slides in and out with a bit of resistance.
Add Fuselage_06 to the previously assembled fuselage parts following the same procedure
as before. Remember to route the Servo extension wires through Fuselage_06
Before assembling Fuselage_05, sand the inside of the thrust tube until the FMS 50mm EDF
unit is easily seated in the tube. Remove the EDF unit and glue Fuselage_05 to the previously
assembled fuselage parts following the same procedure as before.