User Manual

the world‘s best designers united
3DLabGANG project by Michael Hammer
Fuselage Assembly
The fuselage parts are best assembled by applying thin cyano glue to the outside seam. It is
not necessary to glue the edf thrust tube. Make sure the parts are perfectly aligned and start
with one of the “corners”. Use your fingers to press the parts firmly together and apply a
small amount of thin cyano and spray with Accelerator. Pick the next “Corner” and repeat the
procedure. Work your way all around the the fuselage part. When all “corners” are “spot
welded” add thin cyano glue to the entire seam. Wipe of excess glue with a cloth and spray
with accelerator.
Tip of the day:
When assembling two large printed parts, it can be tricky to get the parts to slide together. A
lot of the time you will find that the part slide together in one area but not in the other. Try
running your finger nail along the seam from the area where the parts fit while lightly
pressing the parts together. If done right the parts should snap together.
Start with fuselage_09 and fuselage_08. Use the above described method of “spot welding”