User Manual

the world‘s best designers united
3DLabGANG project by Michael Hammer
Bill of Materials
1mm pianowire
Spring from ball point pen
Cyano hinge sheet
Cyano glue and accelerator spray, medium or thin
2 x HTX900 servoes or similar 9g servos
EDF: FMS 50mm 4S edition available at Aliexpress.com
Receiver: 4-6 ch
ESC: 40A
Battery: 4S2200mAh 25C or higher
3D Printer Requirements
Recommended Prusa MK3S : 250 x 210 x 210 mm, minimum diagonal for wing chord is 297
mm
Nozzle: 0,4mm
Filament: PLA or PolyAir 1.0
Slicing software: Simplify3D
Print settings
All parts are designed to be printed with 0,4mm nozzle, 0,25mm layer height
Before you start slicing the stl-files yourself, I highly recommend printing the supplied G-
Code files first to see if they will print OK on your printer. For many the supplied G-Code
files will do the job just fine. But if you need to slice the stl-files, you can find info in the table
on how best to slice them. A lot of parts are listed with different settings for for different
height intevals. The Simplify 3D slicer with its advanced function with multiple processes
dependent on the z-axis height will handle these settings well.
If using a Slicer which can not handle multiple processes, just print the part with bottom
layers and no top layers. A hot knife or Dremel can be used to remove any unwanted part
when the print is finished.