User Manual

the world‘s best designers united
3DLabGANG project by Michael Hammer
EDF Assembly
Place the two EDF_Mount around the FMS 50mm EDF as shown in the photo. Use small
screws to secure the EDF between the mounts. Do not tighten too much. The EDF fan
should be able to turn freely without rubbing against the shroud. Make sure to cut of the tip
of the screws if they protrude from the mount. Instead of screws you can also use medium
cyano glue.
Insert the EDF and its mount into the fuselage and slide it all the way forward until you can
feel the EDF is completely seated in the EDF duct of Fuselage_05 as shown in the photo
below. Use a length of 0,8mm piano wire as a drill bit to drill pilot holes for the screws.
Secure the EDF with four screws (servo screws).
Pull the EDF_tube out from Fuselage_07 toward the EDF and route the EDF wires through
the hole as shown in the photo. Slide the EDF_Tube all the way onto the EDF unit. Connect
the EDF wires to the ESC. Test the EDF and make sure the sound is "pure whoosh" without
any "unwanted" sounds.