User Manual

the world‘s best designers united
3DLabGANG project by Michael Hammer
Mount the HXT900 or similar servos in the servo mounts with the supplied screws as shown
in the photos. Make sure the servoes are in their neutral position and the servo arm is
pointing straight up. Connect the control horn on the elevons to the servo control arm with
a 1mm piano wire. Use your preferred method of connecting the servo, piano wire and
control horn. Personally I prefer connection with a piano wire with a z-bend in both ends.
Once mounted you will not be able to adjust the length of wire. But you will get a slop free
and reliable connection. Make sure that the length from start of the z in one end to the other
end is 73mm.
Place the Servos and their mounts in the servo pockets. You can glue the servo mount in
place with medium cyano or use 4 small screws to secure each mount. Drill holes with a drill
bit of a smaller size than the screws in order for them to get a firm grip. Mount the screws
and check the servos are firmly secured.