User Manual

the world‘s best designers united
3DLabGANG project by Michael Hammer
Wing Assembly
The outer wings consist of 4 parts and 6 joiners. Test fit the joiners into the slots of
Wing_Left_01 and Wing_Left_02. Make sure that only half of the joiners protrude. If
necessary reposition the joiners in their correct positions. Add thin cyano to the joiners and
spray with accelerator. Now Slide Wing_Left_02 into position with the fuselage. If the fit is
not acceptable, remove Wing_Left_02 and blocksand the mounting surface of the fuselage.
When happy with the fit, glue Wing_Left_02 onto the fuselage using medium thickness
cyano. Make sure the trailing edge of Wing_Left_02 is perfectly aligned with the trailing
edge of the fuselage. Spray with accelerator. Test fit Wing_Left_01. Make sure that
Wing_Left_01 has "LEFT" stamped into it. When happy with the fit, glue Wing_Left_01 onto
the fuselage and Wing_Left_02 using medium thickness cyano. Spray with accelerator.
Repeat the process for the right side wing.
Glue the wingtips on with medium cyano.