User Manual

The vertical stabilizer consists of 4 parts and a joiner. Test fit the joiner into the slot of
Stab_01 and make sure that only half of the joiner protrudes from Stab_01. Slide Stab_02
onto the joiner and check that Stab_01 and 02 fit together nicely. Remove Stab_02 and if
necessary reposition the joiner in its correct position. Add thin cyano to the joiner and spray
with accelerator. Glue Stab_02 onto Stab_01 using medium thickness cyano. Finish the
vertilcal stabilizer with the top, Stab_03. The rudder, Stab_04 is non functional and should
just be glued on in its correct position.
Vertical Stabilizer assembly
the world‘s best designers united
3DLabGANG project by Michael Hammer