User Manual

page 25
... print your plane | www.3DLabPrint.com
Shopping list
Printing material: 2,5 kg of PLA
RC: 12 chanell receiver by your RC system
EDF: Use any 90mm EDF by your choice.
We tested:
12 Blade High-Performance 90mm EDF Unit - high quality
3553-1800 90mm EDF Brushless Fan Motor
Dr Mad Thrust 11-Blade Alloy 90mm - standard quality
Mount strap for 90mm Alloy DPS Fan
or similar for 6S Li-Pol with not so long body...
Controller: 80-100A Electronic Speed Controller
Battery: 2x 3S or 4S Li-Pol 4200-6200mAh used as serial for 6S or 8S
Servos: 9x Hitec HS-81/82MG, Corona CS283MG or similar servos
1x Hitec HS-65 MG or HobbyKing™ HK15178 Analog Servo
or similar
6x servo extension cables 300mm / 12 inch
2x servo extension cables 500mm / 20 inch
Retracts: Electron retracts ER-30eVo or
33mm x 35mm Servoless Retract with 4mm metal pins. for main
legs. For the nose leg 33mm x 35mm Servoless Nose Wheel Retract
with 4mm metal pin.
Legs: Alloy Oleo Strut Set with Wheels and Rubber Tires (main legs)
Alloy Oleo Strut set w/wheels for 90mm/1.20 Class Jet
(one main as nose leg)
Glue: CA Glue - medium or similar medium viscosity CA glue
Activator for CA Glue or similar,
Other: 8mm carbon tube
3x 0,8 mm / 14 AWG pushrod wires or carbon rods
5x 1,2 mm / 16 AWG pushrod wire
fitting screws