User Manual

page 23
... print your plane | www.3DLabPrint.com
10.2. Flying setup
Setup flight modes on your RC system.
Start mode
Flaps down for 15°, lower the undercarriage, 30% expo.
Normal mode
all in neutral, lower/retract the undercarriage, 30%
expo
Fast Fly mode
all in neutral, retract the undercarriage, 40% expo, 70%
elevator, rudder, ailerons
Landing (butterfly) mode
lower the undercarriage, flaps full down 45°, ailerons
up +15mm, elevator slightly down -5mm. 30% expo.
You will need about half EDF power for perfect speed.
aileron
+20mm
-15mm / 15°
+18mm
R 40mm
-20mm
-45mm / 45°
-18mm
L 40mm
flap
elevator
rudder