User Manual

page 22
... print your plane | www.3DLabPrint.com
Centre of Gravity
battery maximal
profile:
35 x 65 mm
1.36 x 2.53 inch
10. RC equipment and final assembly
Glue the controller holder and mount it to the fuselage. Install your receiver, connect battery,
setup servos, etc. with your trasmitter, check the throws an neutrals. Set recommended
deflection according to the videoguide. Check CoG point (see CG- tags on wings). Use
820mm/32inch of 8mm carbon tube for wings reinforcement. Carbon tube marks CoG.
Make sure the battery is placed properly and secured. If battery moves mid-flight it can shift
the center of gravity and aircraft will become uncontrollable!
You will need: Your own Rx/Tx system
2x 3S Li-Pol 4000mAh used as serial for 6S
80-100A Electronic Speed Controller
Adhesive velcro strip (or ZIP) for Li-Pol battery and ESC
Scale markings printed on adhesive foil
Battery bays fits 2900 - 6200mAh with 35x65mm profile.
See video guide #10
8mm carbon tube
length: 820mm/32inch