User Manual

page 19

... print your plane | www.3DLabPrint.com

7.2.1 Landing gear - main legs

Suitable main landing gear legs can be found in this set Alloy Oleo Strut Set with Wheels and

Rubber Tires from Hobbyking. The legs has to be slightly bent to ﬁt into the landing gear slot.

Or you can ﬁnd or make any other suitable legs with the right lenght and wheel oset

according the diagram below.

7.2.2 Landing gear - front leg

One of the main legs in this set Alloy Oleo Strut set w/wheels for 90mm/1.20 Class Jet is

suitable as an ideal front leg, or you can again ﬁnd or make any other leg with the right lenght

and wheel oset according to the image below

See video guide #8

You will need: ﬁtting screws

1x Hitec HS-65 MG

or HobbyKing™ HK15178 Analog Servo or similar

0-15mm/0-0.58inch

25mm/0.97inch

4mm pin

Standard Hobbyking retract with

alloy oleo leg 100mm / 3.90inch.

Electron retracts ER-30eVo

with Electron steering system and

alloy oleo leg 100mm / 3.90inch.

4mm pin

100mm

3.90 inch

105mm

4.13inch