User Manual
page 17
... print your plane | www.3DLabPrint.com
6.1. Servos for aileron, flaps, air brakes, rudder, elevator
Proceed with installing all the servos. Use 1,2 mm wire for pushrods. Make Z bend or use
your preered pushrods fixing method. We like these Pushrod Keepers. Thread pushrods and
hinge the flaps, ailerons, elevators and rudder in correct position.
See video guide #7
You will need: 9x Hitec HS-81/82MG, Corona CS283MG or similar servos
1x Hitec HS-65 MG or HobbyKing™ HK15178 Analog Servo
or similar for front leg
6x servo extension cables 300mm / 12 inch
2x servo extension cables 500mm / 20 inch
1,2 mm / 16 AWG pushrod wires
Wire cutter, Z bend pliers or pliers.