User Manual

page 16
... print your plane | www.3DLabPrint.com
5.3. Fuselage tail - rudder, elevator pushrods and servos
Now it‘s a good time to install the tail stabilizers, elevator, rudder and pushrods. You can
use snap knife to clean the shape of printed parts. Glue together the horizontal and vertical
stabiliser and glue it to the fuselage. UP side of vertical stabiliser is marked. Glue the rudder
and elevator. For hinge use shaped 0,8 mm / 14AWG pushrod wire or carbon rod. You can
clear the holes using hot wire.
See video guide #6
You will need: CA Glue - medium viscosity CA glue
Activator for CA Glue or similar, but gas presurized aerosol is better
0,8 mm /14AWG pushrod wire or carbon rod
1,2 mm / 16 AWG pushrod wires
Wire cutter, Z bend pliers or pliers.
Snap knife
Soldering Iron or any hot tool
rudder 1234
30g/1.19oz
ver. stabiliser 1
19g/0.75oz
V stabiliser 2
16g/0.63oz
V stabiliser 3
3g/0.11oz
hor. stabilizer L 2
12g/0.47oz
hor. stabilizer L 3
3g/0.11oz
hor. stabilizer L 1
21g/0.83oz
air brake R 1, R 2
18g/0.71oz
elevator L 1234
25g/0.99oz