User Manual

2
A
vion
airplanes
DUCK user manual
Avion Airplanes
f
avion_airplanes
I
What you need
Filament
Hardware
Motor
ESC
BEC
Servos
Propeller
Main bat.
RX bat.
RC
Proles
Prusa Slicer
2.4.0
Cura
4.13.0
2x
2x
2x
2x
2x
1x
1x
1x
2x
1x
1x
1x
PLA LW / POLYLIGHT 1.0
PLA
ø1×285mm carbon rod (fuselage)
ø1×571mm carbon rod (wing front)
ø1×487mm carbon rod (wing back)
ø1×361mm carbon rod (elevons)
ø2×385mm carbon rod (elevons axles)
Steel wire, carbon rod or clevis (pushrods)
Snap-o knife
CA glue
Activator
HGLRC Aeolus 2004 1800Kv (my setup)
or similar 20XX size motor
iFlight SucceX-E Slick 45A (my setup)
or similar (with or without BEC)
iFlight Micro 5V 3A (my setup)
external BEC is optional
Corona DS-843MG (my setup, recomended)
HQPROP T5X3 (my setup)
or similar 5“ or 6“
CNHL Ministar 450mAh 6S 70C (my setup)
or 40×18×72mm (max. size for main battery)
Turnigy Nano-Tech 460mAh 2S (my setup)
RX battery is optional
at least 3 channel RC system (elevon mix)
Use 3MF les as starting
point to nd sweet spot with
your printer.
Use included Cura proles as
starting point to nd sweet
spot with your printer.
Possible to print with Prusa Slicer 2.4.0 and Cura.
Before printing big parts make sure, that everything
will t perfectly (carbon rods etc.)