User Manual

22
A
vion
airplanes
DUCK user manual
Avion Airplanes
f
avion_airplanes
I
Completion
You will need
1.
Use ø2×385mm
carbon rod 2x as
elevons axles.
Don‘t insert them
all the way in at
this point in case
that you will need
to make pushrods
or other
adjustments.
2.
Set elevons to neutral
position and install
pushrods. Make sure,
that everything moves
freely. If not, use sand
paper or drillbit and
make necessary
adjustments.
Canopy, W_L_3_Cover, W_R_3_Cover,
ø2×385mm carbon rod 2x (elevons axles),
Steel wire, carbon rod or clevis (pushrods)
CA glue
Completion
3.
If everything moves
freely and pushrods
are installed correctly,
insert ø2×385mm car-
bon rod 2x all the way
in and secure them
with small drop of CA
glue to the elevons.
4.
Install RX and battery. Now you
are ready to start programming
servos and set right CG.