User Manual

page 3
... print your plane | www.3DLabPrint.com
General specifications:
Length: 1220 mm / 48,0 inch
Wingspan: 1563mm / 61.5 inch
Height: 384 mm / 15.1 inch
Wing area: 36 dm2 / 3.9 sq foot
Wing loading: 54 g/dm2 / 17.70 oz at sq foot
Center of gravity: 75 mm (0 in)
from leading edge
See CG tags on wings...
Airfoil: 3DLabPrint modified
Print weight: 1374 g / 48.5 oz
Empty weight (w/o battery): 1724 g / 60.8 oz
Takeo weight (3s 3000 lipo): 1944 g / 68,6 oz
Max takeo weight: 2250 g / 79.4 oz
Never exceed speed, VNE: 100 km/h / 62.14 mph
Design maneuvering speed, VA: 70 km/h / 43.49 mph
Stall speed, VS(full flaps): 24 km/h / 14.9 mph
Powerplant
Propeller: APC 11x5,5
Motor: Turnigy 3542/5 1000-1250KV or similar
ESC: 40A Electronic Speed Controller
or similar 40Amps
Battery: Li-Pol 3000mAh/3s/4s (11.1V),
at least 215g / 7.6oz, 25C
Performance measurement
Max speed VH (level flight): 105 km/h – 56.7kn – 65.2mph with APC 11x6
Rate of climb: 23 m/s (5 373 ft/min) with APC 11x6
Flight time (3s 3000mAh): 7:40 with APC 11x5,5