User Manual

page 16
... print your plane | www.3DLabPrint.com
5.3. Fuselage tail - rudder, elevator pushrods and servos
Now is good time for install tail stabilzers, elevator, rudder and pushrods. Simply push 1 mm
pushrods wires to back part of fuselage (into printed bowden). Make Z bend or use your liked
pushrods attachment, we like this Pushrod Keepers. Thread pushrods and glue the elevator
and rudder in correct position with CAglue. Cut rudder clearence for elevator movement
with soldering Iron or any hot tool.
You can use snap knife to clearing shape of printed parts...
NOTE: horizontal stabilizer must be glued after instaling elevator!!! (elevator is locked with
stabilizer)
NOTE: then asembly rudder with vertical stabilizer add pushrod and glue to the fuselage!!!
See video guide #6
You will need: CA Glue - medium viscosity CA glue
Activator for CA Glue or similar, but gas presurized aerosol is better
1 mm / 18 AWG pushrod wires
Wire cutter, Z bend pliers or pliers.
rudder
23g/81oz
V stabilizer
15g/0.53oz
R Hor stabilizer
25g/0.88oz
R elevator
12g/0.42oz