User Manual

page 14
... print your plane | www.3DLabPrint.com
5. Assembling printed parts
5.1 Wing assembly
Glue wing parts with CA glue together (position locks will help you), use activator. Install
ailerons and flaps. You can use snap knife to clearing shape of some printed parts (mainly for
the installation of the flaps and ailerons), but mostly it is not necessary.
NOTE: wing tips (L7) must be glued as a last , after instaling ailerons!!! (ailerons are locked
with L7)
See video guide #4
you will need: CA Glue - medium or similar medium viscosity CA glue
Activator for CA Glue or similar, but gas presurized aerosol is better
Snap knife
L 1
51g/1.80oz
R strut
12g/0.42oz
L aileron
26g/0.92
L flap
28g/0.98
L 2
55g/1.94oz
L 3
29g/1.02oz
L 4
38g/1.34oz
L 5
46g/1.62oz
L 6
35g/1.23oz
L 7
7g/0.24oz