User Manual

page 18
... print your plane | www.3DLabPrint.com
Shopping list
Printing material: 0,22 kg of LW-PLA by ColorFabb
RC: R/C system, Tx (EU) (GLOBAL) + compatible Rx 4ch, or opt1
we use JETI
Motor: any 10-30grams, 28-05, 2800KV, opt1, opt2, opt3... or similar
+ suitable propeller holder (if not included)
ESC: any 12A/2s, opt1, with caution opt2 or similar
Batt. connector: JST + shring tube
Battery: 350mAh/2s, opt1, opt2, opt3, opt4,
Servos: 2x HXT900, or opt1, opt2, opt3
or any similar sized servos
23x12x26 mm / 0.82x0.47x0.86 inches
Glue: CA Glue - medium
Activator for CA Glue
Other: 2x 1m of 0.8mm / 16 AWG pushrod wire
6x 1.5/10self-tapping screws
Rubber Band (thiny)