User Manual

page 14
... print your plane | www.3DLabPrint.com
5.3 Fuselage tail
Use hot snap knife or any hot tool and cut out print bridge so the elevator can freely move
(you can than cut some longitudal holes so the elevator hinges will be softer). Glue L1 and
L2 parts of the stabilizer, proceede with R side and glue both sides together, then glue whole
stabilizer/elevator to the fuselage.
V stabilizer/rudder - cut out the bridge the same way and glue it to the fuselage.
you will need: CA Glue medium viscosity+ activator
Snap knife, Soldering Iron or any hot tool (dremel torch)
See video guide #6
H stabilizer L1
9g/0.32oz
H stabilizer L2
1g/0.04oz
V stabilizer
10g/0.35oz