User Manual

page 13
... print your plane | www.3DLabPrint.com
5.2 Fuselage assembly
You can use snap knife for cleaning the surface of printed parts (joining spots), but mostly it
is not necessary.
Glue fuselage parts F1-F6 with CA glue together. The new 3DLabPrint lock system will help you.
Use any hot tool to cut out the hole for rubber band in F4 part (main wing join).
See video guide #5
you will need: CA Glue medium viscosity + activator
Snap knife, Soldering Iron or any hot tool (dremel torch)
F1
11g/0.39oz
F2
22g/0.78oz
F3
12g/0.42oz
F4
7g/0.25oz
motor mount
4g/0.14oz
spinner
4g/0.14oz
F5
6g/0.21oz
F6
8g/0.28oz