User Manual

page 17
... print your plane | www.3DLabPrint.com
10. Go flying
Before flight check: center of gravity is very important (move it forward for the first flights
see CG markings and chapter 11 bellow), battery properly charged, ailerons and elevator
deflection check, your own flying skills or RC simulator training...
Then go flying: set full throtle, put the elevator little upwards (1-2mm) and throw it energet-
ically to the wind approx 10 grades up, wait till plane gain speed, then fly it in your manner...
See video guide #11
11.Pilots Please Attention!!!
For the first flights we recommend set center of gravity of the airplane by about 5 mm for-
ward of the CG tag (nose heavy, this increases the stability) is also good to increase expo
settings on your transmitter for elevator and ailerons to 80 % (this calms response from
your stick inputs)
Also you can decrease elevator and ailerons deflection.
Make sure the battery is well fixed in proper possition if it moves during flight it will cause
move CoG aft and will lead to uncontrolable flight behavior...
You can then return to the center of gravity (balance aircraft)the CoG points and expo set to
60 % as stated in the video/instructions... this gain back extra maneuverability when you will
be sure with flying your airplane.
!!!Never fly aft positioned CoG!!!
And Please, use this files only for your own purpose, do not
send further... Thank you very much