User Manual

page 16
... print your plane | www.3DLabPrint.com
7. R/C Equipment instaling
Instal prepared RC equipment: Motor, ESC, Servos...
Nose and motor mount are already in angle for compensating rotating propeller stream.
See video guide #8
you will need: Printed motor mount, find the one that fits for your motor...
2-4x Screw 3/12-30mm depends on motor-mount
Small screwdriver+
Your earlier prepared R/C equipment
3x Self Tapping Screw M3x8mm or similar
8. Pushrods
Made steel pushrod for ailerons, elevator, rudder and connect within servo arms...
See video guide #9
you will need: Steel pushrod, diameter 1.0mm
Pliers
CA Glue - medium
Activator for CA Glue or similar, but not mechanical is better
9. Finalization
Instal your reciever, connect batery, setup servos and etc. with your trasmitter, lock servo
position, then instal propeller...
!!!Make sure that the battery is placed properly and secured with wing battery holder, if
battery moves during flight it can shifts the center of gravity backwards and aircraft will be
uncontrollable!!!
See video guide #10
you will need: Your own Rx/Tx system
Battery for your setup...
2xRubber rings
Foam strip for Li-Pol battery
Scissors
Propeller + printed spinner
Small screwdriver+
CA Glue - medium + activator
Scale markings printed to adhesive foil
!!!Never set ESC with instaled propeller, this is very dangerous!!!