User Manual

page 14
... print your plane | www.3DLabPrint.com
5. Assembling printed parts
5.1 Wing assembling
Glue wing parts with CAglue together, use activator and instal ailerons...
See video guide #4
you will need: CA Glue - medium or similar medium viscosity CA glue
Activator for CA Glue or similar, but not-mechanical is better
AC Hinge Sheet or similar
Scissors
Snap knife
Some cloth for wiping CA glue...
5.2 Fuselage assembling
Glue with CAglue fuselage parts together, use activator, instal elevator, fine tune parts shape
with knife or sandpaper. Assembly wing and underfuselage part. When gluing part 1 and 2
remember there is on the upper side air outcome.
See video guide #5
you will need: CA Glue - medium or similar medium viscosity CA glue
Activator for CA Glue or similar, but not mechanical is better
AC Hinge Sheet or similar
Scissors
Snap knife or Sandpaper
Optionaly some cloth for wiping CA glue...