User Manual

page 13
... print your plane | www.3DLabPrint.com
Basic Typs and Advices
Plese Experiment with your extrusion multiplier...
Also HotEnd temperature is very important for strong result, please try increase tempera-
ture to find the best value (200 up to 260 celsius)
Turn OFF cooling fan for better layer adhesion (HE fan of course ON) we dont need it for
our thin wall printing...
We try lot of filaments and so far PLA is still the best for our models (2016).
You can try aslo PETG and PC-max from polymaker is very promising filament.
HEATED BED is very recommended, 60-70celsius (print without warping ends)
Looks like any standard quality PLA is OK for our planes, BUT it always depends on combi-
nation PLA vs. Extruder vs. HotEnd.
We find that some color of filament has lower layer adhesion also.
Nowadays there is lot of 3dprinters on the market, very most of them is OK for printing our
aircrafts (specific thin wall printing...) suficient volume, heated bed, 0.4mm nozzle.
Please give a look to Printing Guide: