User Manual

page 26
... print your plane | www.3DLabPrint.com
4.3 Fuselage tail and assembly.
Now it‘s a good time to assemble the tail stabilizers, elevator and rudder.
Proceed the way shown in videoguide:
See video guide #4.3
You will need: CA Glue - medium or similar medium viscosity CA glue
Activator for CA Glue or similar, but gas presurized aerosol is better
8x 3.5/20mm self-tapping screws
12/750mm carbon tube
1.5mm carbon rod, or steel wire (rudder hinges)
H stabilizer L
52g/1.83oz
elevator L
29g/1.02oz
V stabilizer
29g/1.02oz
rudder
21g/0.74oz
The weight of parts can vary +/- 8% due to di PLA color or brand...!!!