User Manual

page 23
... print your plane | www.3DLabPrint.com
Proceed the way shown in videoguide:
See video guide #4.2
Glue the fuselage parts F2-F3 with CA glue together. You can use snap knife to clean the
shape of printed parts, but mostly this is not necessary.
Glue in the „sure bonds“ (small triangle parts) to the slots in fuselage (F2-F3 parts):
Go ahead and glue fuselage together parts as shown on the picture below:
Now you can proceed with next fuselage parts, there is a bit dierent coupling system
(bayonet coupling) proceed the same way as with the wing assembly: