User Manual

page 15
... print your plane | www.3DLabPrint.com
Start with glueing the engine gondola and wing1 parts (shown in the picture below):
If you want to use engine sound system, this is the time to install the self-adhesive vibration
speakers, use a hot tool to cut the hole for speaker cable (the smaller area marked red in the
picture). Stick the speaker to botom of the pod (use IP alcohol to degrease contact surface):
Proceed the way shown in videoguide:
See video guide #4.1
Apply CA glue to the contact surfaces (marked red in the picture) and assemble together,
then apply the activator, proceed this way with gondola parts and glue them together: