User Manual

page 25
... print your plane | www.3DLabPrint.com
Shopping list
Printing material: 0,60 kg of LW-PLA by ColorFabb
a little piece of PLA or PETG (for motor, guns, wheels, struts,
motor mount, spinner, ...)
RC: R/C system, Tx (EU) (GLOBAL) + compatible Rx 5ch, or opt1
we use JETI
Motor: any motor 2830 size for 3S Li-Pol with weight up to 80-60g
opt1, opt2, opt3, opt4... or similar
Leopard LC2830 980KV (for 3S setup)
ESC: 20A/3s, opt1, opt2, opt3, opt4... or similar
Battery: 1800mAh/3s, opt1, opt2, opt3, opt4 weight around 150-180g
or use 1300/3s + nose ballast to achieve proper CG
Servos: 4x HXT900, or opt1, opt2, opt3
or any similar sized servos
23x12x26 mm / 0.82x0.47x0.86 inches
Glue: CA Glue - medium & thin
Activator for CA Glue
Other: 2x servo extension cables 300mm / 12 inch
1x 1m of 1 - 1,2 mm / 14 AWG pushrod wire or carbon rod
1x 1,3m of 3 mm carbon or fiberglass rod
1x 1m of 0,8 mm pushrod wire
4x M3 screws
1x M4 nut & nylon screw
14x 2x8 screws