User Manual

page 23
... print your plane | www.3DLabPrint.com
9. Go flying
Pre-flight check center of gravity is very important (move it 5mm forward for the first flights),
battery properly charged, ailerons and elevator deflection check, your own flying skills or RC
simulator training ...
NOTE: this is biplane so use also rudder controll...
Flight video of Albatros D.Va
aileron elevator rudder
+15mm
+15mm 30mm L
-10mm -15mm 30mm R
8. Final setup & Painting/marking
Paint the plane with your favourite livery. You can find inspiration at http://www.wingnutwings.
com/ww/ You can use our scale PDF for making painting templates for easy paint job.
Refer to your R/C system userguide for setup information.
Install your reciever, connect battery, setup servos etc. with your trasmitter, check servo
throws, then install propeller. Make sure the battery is positioned properly and secured with
wing battery holder, if battery moves during flight it can shift the center of gravity backwards
and aircraft will become uncontrollable!
Never set ESC with propeller installed, this could be very dangerous!
you will need: Your own Rx/Tx system
See video guide #11