User Manual
page 22
... print your plane | www.3DLabPrint.com
7.3 Fuselage and Wing struts - Final assembly/setting
Mount all pins to the fuselage and wing struts. All pins are the same. Use 2 x 8 mm screws.
You can find suitable screws in each HXT900 servo package. You can use wire from oce pin
too but there will be a slight play in the joint. Push M4 nut to the prepared slot in the fuselage.
Fix the lower wing using M4 nylon screw. Left and right wing struts are symetrical. Fuselage
struts are marked by L and R letters. Letters should be visible in front and up when assembled.
Push completed struts with pins to the fusellage and wings. Double check the wing and
fuselage position and glue all pins using thin CA.
you will need: 14x 2x8mm screw
1x M4 nut & nylon screw M4
See video guide #9
fuselage strut L
6.0g/0.20oz PLA
wing strut
6.0g/0.20oz PLA
fuselage pins
0.2g/0.01oz PLA
L mark
front and up
wing pins
0.2g/0.01oz PLA
M4 nut & nylon screw