User Manual

page 21
... print your plane | www.3DLabPrint.com
7.2 Fuselage - motor mount & ESC & battery holder
Mount the motor using 4x M3 screws and nuts to the printed universal motor holder 16 x
19mm. For long motors you can flip the holder to the front (as at picture). The whole set
push to the fuselage, check the gap between fuselage and spinner. Simply glue it from back
side. Glue universal motor mount with motor into the fuselage in right position. Glue battery
holder in front of fuselage. Fix the battery (150-180g pack needed) by velcro tape and mount
it in the front of the fuselage, find the perfect balance and CG position by moving it.
you will need: CA Glue thin viscosity + activator (or medium CA glue)
4x M3 screws
See video guide #10
motor mount
9,5g/0.33oz
PLA or PETG
LW planes setup - (230W)
Motor: any 2830 1000KV, opt1, opt2, opt3, opt4... or similar
ESC: any 20A/3s, opt1, opt2, opt3, opt4... or similar
Propeller: two blade slow flyer APC 10 x 4,7 SF
Battery: 1800mAh/3s, opt1, opt2, opt3, opt4
Batt. connector: XT60 or Gold Conn
printed PLA or PETG mount 16 x 19 mm