User Manual

page 20
... print your plane | www.3DLabPrint.com
6. Servo installation
Cut loose the servo holder ears on aileron servos. Install the prepared servos to wing servo
bays. Use a 1mm steel wire with Z bends as a linkage between the servos and aileron control
horns. Elevator and rudder servo will be fixed directly to the fuselage by included screws.
See video guide #8
you will need: 4x HXT900, or opt1, opt2, opt3
or any similar sized servos
23x12x26 mm / 0.74x0.42x0.78 inches
2x servo extension cables 300mm / 12 inch
Snap knife, Z pliers
medium CA glue or hot glue
servo tester or your RC system