User Manual

page 19
... print your plane | www.3DLabPrint.com
5.2.4 Fuselage tail skid
Glue L and R parts of the tail skid together. Glue pin (from wing or fuselage pin pack) to the
fuselage. Hinge tail skid by wire from oce pin. Band a rubber band around tail skid. Tail skid
should move freely. Check the functionality of the tail skid assembly.
you will need: CA Glue thin viscosity + activator (or medium CA glue)
0,8 - 1 mm steel wire or oce pin
1x oce rubber band
See video guide #7
tail skid (pair)
3,5g/0.12oz PLA
pin
0,2g/0.01oz PLA