User Manual
page 18
... print your plane | www.3DLabPrint.com
5.2.3 Fuselage gear
Slide the 240 mm long 3 mm carbon rod into the axle cover and fix it with CA glue followed
by glueing both axle rollers (keep a small gap between the roller and axle cover). Assemble
left and right side of the landing gear using carbon fibre rods and junction parts. Fix the rollers
to the junctions using rubber rings. Practice the rubber ring joint and make it reasonable soft
for smoother landings. Install tyres on disks and secure the wheels on axle using collars.Make
sure the wheels rotate freely. Slide in the landing gear to the fuselage. Don‘t glue the rods in
for easy replacement. If you decide to glue the gear in the fuselage, do it only on the rear side,
or you won‘t be able to install bottom wing.
Note: if your flex material for printing tyres is too thick, cut the disk STLs in half and print
separately. You can also use o the shelf 60x10 mm rubber O rings as tyres.
you will need: CA Glue thin viscosity + activator (or medium CA glue)
3 mm carbon rod, 1pc 240mm, 2pcs 150mm, 2pcs 210mm
2x oce rubber band
See video guide #7
axle cover
6g/0.21oz LW
3mm carbon rod
240 mm
3 mm carbon rod
150 mm
disc
12g/0.42oz PLA
tyre
17g/0.59oz FLEX
junction
3,0g/0.11oz PLA
spool
1,7g/0.05oz PLA
3mm carbon rod
210 mm
don‘t glue
in front