User Manual

page 17
... print your plane | www.3DLabPrint.com
5.2.2 Fuselage tail - elevator pushrods and servos
Glue L1 and L2 parts of the stabilizer and elevator. The profile is symmetric, so the left and
right sides are identical. Pay attention to alignment of the stabilizers against the fuselage.
Make a Z bend on the elevator and rudder 0,8 mm pushrod wire. Mount the elevator assembly
to the stabilizer using the 0,8 - 1,2 mm carbon rod or steel wire. Just slide it in, there‘s no
need to glue the hinge for easy aileron or servo replacement. Elevator and rudder should
move freely, controlled by the pushrod and servo. Check the functionality of the elevator and
rudder assembly.
you will need: CA Glue thin viscosity + activator (or medium CA glue)
needle applicator (needed for thin CA glue)
0,8 - 1 mm steel wire for elevator pushrod
0,8 - 1 mm carbon or steel wire for elevator and rudder hinge
Snap knife, Some cloth for wiping CA glue...
See video guide #6
stabiliser L2
3,0g/0.10oz LW
elevator L1
1,5g/0.05oz LW
elevator L2
3,0g/0.10oz LW
elevator L2
1,0g/0.03oz LW
stabiliser L1
7,5g/0.26oz LW
rudder 3
3,0g/0.10oz LW
rudder 2
3,0g/0.10oz LW
rudder 1
2,0g/0.07oz LW