User Manual

page 15
... print your plane | www.3DLabPrint.com
5. Assembly of printed parts
5.1 Wing assembly Albatros D.Va
Glue wing parts L1-L4 together using thin CA glue method (with needle applicator). Repeat
for the right side. Glue both halves of the wing together. Repeat the procedure for bottom
wing. Use the activator for instant curing the glue. You can use aslo clasic medium CA glue
(also shown in the video)
Assemble and glue the ailerons L1-L4 on a flat surface (pay attention for negatives, tips should
point upwards!) and repeat for the right side. Use a suitable 0,8mm - 1,2mm carbon rod or
wire as a hinge for the ailerons. Just slide it in, there‘s no need to glue the hinge for easy
aileron or servo replacement.
See video guide #4
you will need: CA Glue thin viscosity + activator (or medium CA glue)
needle applicator (needed for thin CA glue)
0,8 - 1,2 mm carbon, fiberglass or steel wire for aileron hinge
Snap knife, Some cloth for wiping CA glue...
wing bottom 1
10g/0.35oz LW
wing bottom L2
11g/0.38oz LW
wing bottom L3
16g/0.56oz LW
wing bottom L4
16g/0.56oz LW
wing upper L1
22g/0.77oz LW
wing upper L2
21g/0.74oz LW
wing upper L3
17g/0.59oz LW
wing upper L4
0,5g/0.01oz LW
aileron L1
1,6g/0.06oz LW
aileron L2
1,6g/0.06oz LW
aileron L3
3g/0.10oz LW
aileron L4
4,5g/0.16oz LW
end of aileron
curved up
R wing
completed