User Manual

page 14
... print your plane | www.3DLabPrint.com
How to print LW-PLA?
The basic print setup is almost the same as we use for standard
PLA. The only dierence is in extrusion multiplier set to 0.5 and
turning o the retractions completely.
This results in parts with half the weight and still suitable
mechanical properties. All LW parts of our Albatros are designed
to be printed in vase mode!
The nozzle is permanently pressurized, so it‘s less prone to
print failures. This method works fine even for bowden printers.
Extrusion multiplier 0,5 has been tested for easy print with
massive weight saving around 50%. Feel free to experiment
with extrusion multiplier and temperatures to achieve the best
results on your printer.
Cosmetic printing issues are easily fixed with snap knife or
sand paper, as the LW is easily sanded and cut.
Ocial guide by ColorFab - How to print LW-PLA
How to glue LW-PLA?
The new 3DLabPrint locking system allows a new method of
glueing using thin CA. Dry assemble parts together and align
them. Add few drops of thin CA glue using needle applicator
and let it pour into the joint. Wipe any excess glue with a
napkin, then apply activator for instant curing. The result is
strong, clean, perfect joint.
colorFabb B.V.
The Netherlands
LW-PLA
shop:
https://colorfabb.com/
lw-pla-natural
email sales:
[e-mail]
email support:
[e-mail]