User Manual

page 21
... print your plane | www.3DLabPrint.com
Shopping list A6M2 ZERO:
Printing material: 0,25 kg of Polylight LW-PLA
a few of PolyAir PLA or PETG filament
Motor: any 2830 size motor for 3S Li-Pol with weight up to 70g
Propeller: GWS 9 x 7,5 (ugly orange) or any 9x6
ESC: any 20A/3s Brushless Speed Controler + connector XT60
Battery: any 1500mAh / 3s, 140-160g
Servos: 3x HXT900, or similar 23x12x26 mm
Glue: CA Glue - medium
Activator for CA Glue
Other: 0.75m of 0.8-1.0 mm pushrod wire
4x M3/8mm screws + washers, velcro tape, 4x rubber bands