User Manual

page 19
... print your plane | www.3DLabPrint.com
8. Final assembly/setting
Refer to your R/C system userguide for setup information.
Video guide A6M2 ZERO Final Setting
you will need: Your own Rx/Tx system (refer to your R/C system userguide for setup)
4x rubber bands
Install your reciever, connect battery, setup servos and etc. with your trasmitter, check servo
position, then install propeller, the supplied spinner guarantees proper cooling of the motor
and mount.
Make sure the battery is positioned properly and secured with wing battery holder, if battery
moves during flight it can shift the center of gravity backwards and aircraft will become
uncontrollable! Never set ESC with propeller installed, this could be very dangerous!
9. Go flying
Pre-flight check center of gravity is very important (move it 5mm forward for the first flights),
battery properly charged, ailerons and elevator deflection check, your own flying skills or RC
simulator training ...
Flyght video of A6M2 Zero
aileron elevator
+15mm
+15mm
-12mm -15mm