User Manual

page 16

... print your plane | www.3DLabPrint.com

5.2.1 Fuselage assembly A6M2 Zero

You can use snap knife for cleaning the surface of printed parts, but mostly it is not necessary.

Glue fuselage parts F1-F4 with CA glue together. The new 3DLabPrint lock system will help

you.

Check the alignment of F4 part compared to the wing before glueing. Do not glue rudder

part before tail and elevator assembly. Use any hot tool to remove the unnecessary material

from F4 tail part for the elevator arm.

Insert two 110 mm long 3 mm diameter carbon rods making a rubber band wing holders. No

need to glue it for easy replacement. Wall thickness should be 0.60-0.67.

For fuselage cover arm use a ball pen spring. Put it to the part 2 and glue with part 1 together.

NOTE: Don‘t glue the rudder tailpart yet !!! (proceed to the next step for elevator and

stabilizer assembly)

See video guide A6M2 ZERO Fusselage Assembly

you will need: CA Glue - medium + Activator for CA Glue

Snap knife, SandPaper Some cloth for wiping CA glue...

BallPen Spring

23g/0.81oz LW

16g/0.56oz LW

15g/0.52oz LW

13g/0.45oz LW

ball pen spring

motor mount

11g/0.38oz PLA

spinner

6g/0.21oz PLA

cowl

19g/0.67oz PLA

cover 1

2,2g/0.08oz LW

cover 3

7,1g/0.25oz LW

cover arm

1g/0.03oz LW

2,8g/0.10oz PLA

cover 2

3,2g/0.11oz LW