User's Manual

User Manual

Fire ID TM-801-EN

General Safety Guidelines

This device has been designed and tested to meet strict safety requirements applicable to IT

equipment, and has been supplied in a safe condition. 3D Imaging & Simulations Corp.

assumes no liability for failure to comply.

If this device is not used as specified, the protection provided by the device could be impaired.

This device must be used in a normal condition only.

There are no user serviceable parts inside this device. The device should only be opened and

serviced by qualified service personnel. If there is a service problem, please contact 3D

Imaging & Simulations Corp. or authorized dealer.

Do not spill liquids on the device, and never operate the device in a wet environment.

Keep the device from radiators and heat sources.

Use the device only with accessories supplied with this device.

This device contains static sensitive components. Proper static handling procedures and

equipment must be used when servicing this device.

If any of the following conditions occur, unplug the device from the PC to USB cable and contact

authorized service personnel.

z The USB cable is damaged.

z An object has fallen into the device.

z The device has been exposed to water.

z The device has been dropped or damaged.

z The device does not operate correctly when the operating instructions are followed.